SHERWIN-WILLIAMS CO,KRYLON PROD GROUP,SPEC GROUP -- 1302 ACRYLIC CRYSTAL
CLEAR -- 8010-00-873-9315 ===================== Product Identification =====================
Product ID:1302 ACRYLIC CRYSTAL CLEAR
MSDS Date:07/20/1994
FSC:8010
NIIN:00-873-9315
MSDS Number: BXCBB
=== Responsible Party ===
Company Name:SHERWIN-WILLIAMS CO,KRYLON PROD GROUP,SPEC GROUP
Address:31500 SOLON ROAD
City:SOLON
State:OH
ZIP:44139
Country:US
Info Phone Num:800-247-3266
Emergency Phone Num:216-292-7400
CAGE:54636
=== Contractor Identification ===
Company Name:SAX ARTS & CRAFTS SUB OF BEATRICE COMPANIES INC
Address:2405 S CALHOUN RD
Box:City:NEW BERLIN
State:WI
ZIP:53151
Country:US
Phone:262-784-6880
CAGE:26290
Company Name:SHERWIN-WILLIAMS CO THE
Address:101 PROSPECT AVE NW
Box:City:CLEVELAND
State:OH
ZIP:44115-1042
Country:US
Phone:800-251-2486/216-566-2242
CAGE:54636
============= Composition/Information on Ingredients =============
Ingred Name:PROPANE (PROPELLANT)
CAS:74-98-6
RTECS #:TX2275000
Fraction by Wt: 13%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:1000 PPM
ACGIH TLV:ASPHYXIANT; 9394
Ingred Name:ISOBUTANE (PROPELLANT)
CAS:75-28-5
RTECS #:TZ4300000
Fraction by Wt: 17%
Other REC Limits:NONE RECOMMENDED
Ingred Name:VM & P NAPHTHA
CAS:64742-89-8
Fraction by Wt: 22%
Other REC Limits:NONE RECOMMENDED
Ingred Name:ETHYL BENZENE (SARA III)
CAS:100-41-4
RTECS #:DA0700000
Fraction by Wt: 2%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:100 PPM
ACGIH TLV:100 PPM/125STEL;9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ingred Name:TOLUENE (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 12%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:200 PPM; Z-2
ACGIH TLV:S, 50 PPM; 9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ingred Name:XYLENE (SARA III)
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 14%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:100 PPM
ACGIH TLV:100 PPM/150STEL;9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ingred Name:ACETONE (SARA III)
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 11%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:1000 PPM
ACGIH TLV:750PPM/1000STEL;9294
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS
Ingred Name:VOLITILE ORGANIC CONTENT AS LISTED ON MSDS AS % BY WT PER
BAAQMD RULE 49, 94%.
RTECS #:9999999VC
Other REC Limits:NONE RECOMMENDED
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:IRRIT OF EYES/SKIN/RESP SYSTEM. MAY
CAUSE NERVOUS SYSTEM DEPRESSION. EXTREME OVEREXPO MAY RESULT IN
UNCONSC & POSSIBLE DEATH. PROLONG/REPEAT OVEREXPO TO HEXANE:DAMAGE
TO NERVE TISSUE OF ARMS/LEGS(PERI PHERAL NEUROPATHY)RESULT:MUSCULAR
WEK,LOSS SENSATION.INCREASED BY PRESENCE OF MEK.PROLONG OVEREXPO TO
SOLVENT:MAY (SUPP)
Explanation of Carcinogenicity:PER MSDS:NOT INGRED IN PRODUCT IS
IARC/NTP/OSHA LISTED CARCINOGEN.
Effects of Overexposure:HEADACHE, DIZZINESS, NAUSEA, & LOSS OF
COORDINATION ARE INDICATIONS OF EXCESSIVE EXPO TO VAP/SPRAY MISTS.
REDNESS & ITCHING OR BURNING SENSATION MAY INDICATE EYE/EXCESSIVE
SKIN EXPO.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.
======================= First Aid Measures =======================
First Aid:INHAL:REMOVE FROM EXPO. RESTORE BREATHING. KEEP WARM/QUIET.
SKIN:WASH AREA THOROUGHLY W/SOAP/WATER. REMOVE CONTAMIN CLOTH.
EYES:FLUSH W/LG AMTS OF WATER FOR 15MINS. GET MED ATTN. INGEST:GET
MED ATTN.
===================== Fire Fighting Measures =====================
Flash Point Method:PMCC
Flash Point:<21F,<-6C
Lower Limits:0.9
Upper Limits:13.1
Extinguishing Media:EXTREMELY FLAMMABLE. CARBON DIOXIDE, DRY CHEMICAL,
FOAM.
Fire Fighting Procedures:FULL PROT EQPMT INCULDING SCBA SHOULD BE
USED.WATERSPRAY MAY BE INEFFECTIVE.IF WATER USED FOG NOZZ ARE
PREFERABLE.COOL CLSD CNTNR W/WATER TO PREVENT PRESS (SUP)
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT/ELECTR
EQPMT/SPARKS/OPEN FLAME.CLSD CNTNRS MAY EXPL WHEN EXPO TO EXT
HEAT.APPLICATION TO HOT SURFACES REQUIRES SPEC PRECAUT.DURING EMERG
(SUP)
================== Accidental Release Measures ==================
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE &
REMOVE WITH INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:USE ONLY W/ADEQ VENTI.AVOID SKIN/EYE
CONTACT.EXT FLAMM.KEEP AWAY FRM HEAT/SPARKS/OPN FLAME.VAP
ACCUMU-IGN EXPLO.
Other Precautions:MAY CONTAIN MATL CLASSIFIED AS NUISANCE
PARTICULATES-MAY BE PRESENT @HAZ LEVELS ONLY DURING
SANDING/ABRADING OF DRIED FILM.APPLICABLE LIMITS FOR NUISANCE DUST
10MG/M3 ACGIH TLV TOT DUST & 15MG/M3 OSHA PEL,5MG/M3 RESP
FRACTION.STORAGE:1A.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF PERSONAL EXPO CANNOT BE CONTROLLED BELOW
APPLICABLE LIMITS BY VENTI WEAR PROPERLY FITTED ORG VAP/PARTICULATE
RESP APPROVED BY NIOSH/MSHA FOR PROT AGAINST
INGREDS.SAND/WIREBRUSH/ABRADE/VVURN/WELD DR IED FILM WEAR PART
RESP-PROT FRM NONVOLI
Ventilation:LOC EXHA PREFERABLE.GEN EXHA ACCEPTABLE IF EXPO TO INGRED
BELOW APPLICABLE EXPO LIMITS.REFER:OSHA STD 1910.94,107,108.
Protective Gloves:NONE REQUIRED FOR NORMAL APPLICATION
Eye Protection:SAF SPECTACLES W/UNPERFORATED SIDESHIELD
Other Protective Equipment:LONG/REPEAT SKIN CONTACT WEAR CHEM RESISTANT
GLOVES.INTENTIONAL MISUE BY DELIBERATELY CONC/INHAL CAN BE HARMFUL.
Work Hygienic Practices:WASH CONTAMIN CLOTH BEF REUSE.WASH HANDS AFT
USING.USE APPROP BOND/GROUND TECH.NO SMOKING.TEMPS <120F.AVOID
BREATH VAP.
Supplemental Safety and Health
FIREFIGHT:BUILDUP/POSSIBLE AUTOIGN/EXPLO WHEN EXPO TO EXT HEAT.
FIRE/EXPLO HAZ:CONDITIONS OVEREXPO TO DECOMP PROD MAY CAUSE HEALTH
HAZ.SYMP NOT APPARENT IMMED-GET MED ATTN. HEALTH HAZ:CAUSE ADVERSE
EF FECTS TO LIVER/URINARY/BLOOD-FORMING/CARDIOVASCULAR/REPROD
SYS.REPORTS ASSOC REP/PROL OVEREXPO W/PERM BRAIN/CNS DAMAGE.
================== Physical/Chemical Properties ==================
HCC:V3
Boiling Pt:B.P. Text:<0F,<-18C
Vapor Density:>AIR
Evaporation Rate & Reference:FASTER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER. HOWEVER
AVOID HIGH TEMP/ALL IGN SOURCES(OPN FLAME/PILOT
LIGHT/RADIATORS/STOVE/HOT WATER)
Hazardous Decomposition Products:BY FIRE:CARBON MONOXIDE AND CARBON
DIOXIDE
==================== Disposal Considerations ====================
Waste Disposal Methods:WASTE FRM PROD MAY BE HAZ AS DEFINED UNDER
RESOURCE CONVERVATION&RECOVERY ACT(RCRA)40CFR261.WASTE MUST BE
TESTED FOR IGN TO DETERMINE APPLICABLE EPA HAZ WASTE NOS.DO NOT
INCINETAE.DEPRESSURIZE CNTNR.D ISPOSE OF IAW FED/STATE/LOC REGS FOR
POLLUTION.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.